 |
Spars, Rigging, and Hardware for SailboatsRig-Rite, Inc. |
|
Spars, Rigging, and Hardware for SailboatsRig-Rite, Inc. |
| Spinnaker Cars for SS Tracks |
|
|
| These Spinnaker Cars are designed to fit on a variety of Stainless Steel Tracks, and are held in place on the track either by a spring or screw pin. SS Spinnaker Tracks are common on smaller boats and dinghies. Older large boats frequently used SS Flat Track, with a separate riser underneath, in the days before these tracks were replaced by the more economical Aluminum T-Track. Since the Aluminum T-Track was produced in the same sizes as the SS Flat Track, cars for both Tracks are generally interchangeable. Therefore Spinnaker Cars to fit SS Flat Track are listed under Spinnaker Cars for T-Tracks. | |
|
|
|
| Spinnaker Cars for Stainless
Steel Track
Cars for 7/8" SS Internal "C" Track (NF-248/RF-390) For 3/4", 7/8", 1" & 1 1/4" SS Flat Track, See Spinnaker Cars for T-Tracks. |
|
|
|
|
| Spinnaker Cars for 5/8" Sailtrack | |
|
Spinnaker Car for 5/8" Sailtrack: Sch 73-25X:
Welded SS Spinnaker Car to fit 5/8" Sailtrack. Formed SS Slide with SS Spring Pin is welded to 1/4" x 1 1/4" ID Ring. Slide is 3" long x (maximum) 7/8" wide, and projects 1 3/4" (maximum) from Track surface.
|
 |
|
|
|
| Spinnaker Cars for 7/8" Sailtrack | |
|
Spinnaker Car for 7/8" Sailtrack: Sch 73-29X:
Welded SS Spinnaker Car to fit 7/8" Sailtrack. Formed SS Slide with SS Spring Pin is welded to 1/4" x 1 1/4" ID Ring. Slide is 3" long x (maximum) 1" wide, and projects 1 3/4" (maximum) from Track surface.
|
 |
|
|
|
| Spinnaker Cars for 7/8" Internal C-Track | |
|
Spinnaker Car for 7/8" Internal SS C-Track: RF 42X:
Welded SS Spinnaker Car to fit 7/8" Internal C-Track (NF-248, or RF-390). Formed SS Slide with SS Spring Pin is welded to 1/4" x 7/8" ID Ring. Slide is 2 7/8" long x 7/8" wide, and projects 1 1/2" (maximum) from Track surface.
|
|
~ Back to Spinnaker Car Main Page ~
~ Home ~
~