Your cart

Shipping and discount codes are added at checkout.

Spars, Rigging, and Hardware for Sailboats

Rig-Rite, Inc.
Phone: (001) 401-739-1140 -- FAX: (001) 401-739-1149          Ordering/Questions

E-Section Cut-away Internal Outhaul Assembly

E-section Cut-away Internal Outhaul Assembly: K-43008:

Lightweight cast aluminum 3-sheave boom end fits in boom with cut-away end for minimum weight. Includes centerline aluminum outhaul sheave for up to 3/16" wire or 3/8" line, (2) 1 7/8" aluminum sheaves for 3/8" reef lines, and 3/8" clevis pin for topping lift attachment. Minimum weight end fitting requires 2 1/4" tube cutout on top and angle cut on bottom to mount.



Replacement Casting only for E-section Cut-away Outhaul: K-10365:

Casting only, as used in K-43008.


Outhaul Sheave for E-section Outhaul Ass'y: K-198-8A:

Anodized aluminum sheave is 2" OD x 31/64" wide x 3/8" ID.



Reefing Sheave for E-section Outhaul Ass'y: K-10400:

Anodized aluminum sheave is 1 7/8" OD x 7/16" wide x 3/8" ID.


Sheave Axle for E-section Cut-away Outhaul Ass'y: K-10382:

SS Sheave Axle pin is 3/8" diameter x 2.05" grip, with a turned groove on each end to accept 3/8" SS Snap Rings, K-63015 (2 included).



SS Snap Rings for 3/8" Axle Pin: K-63015-2P:

In 2-pack. Require small snap ring pliers for attachment.



Clevis Pin for E-section Outhaul Ass'y: CP6-30K:
SS clevis pin is 3/8" diameter x 15/16" grip length.

~ Back to E-Section Boom Page ~

~ Back to Kenyon Main Page ~

~ Home ~