 |
Spars, Rigging, and Hardware for SailboatsRig-Rite, Inc. |
2 3/8" OD Spinnaker Poles & Fittings |
|
|
|
|
|
Spars, Rigging, and Hardware for SailboatsRig-Rite, Inc. |
2 3/8" OD Spinnaker Poles & Fittings |
|
|
|
|
| Standard 2 3/8" OD Spinnaker Pole Tube Measurements: 2.37" OD x 2.25" ID (60.3mm x 57mm) Wall Thickness: .065" Weight/ft.: .. Moments of inertia: Circumference: 7.45" Alloy: 6063-T6 Stock Lengths: N/A Common Boat usage: 20' - 29' LOA |
|
|
2 3/8" OD Standard Spinnaker Pole Tube was used in a variety of applications,
including Spinnaker Poles, and Whisker Poles.
Standard Pole Fittings for this tube size are listed below.
|
|
|
|
|
|
Standard 2 3/8" OD Spinnaker Pole Tube 2 3/8" OD Spinnaker Pole Tube - Clear Anodized: RTA 2.37-065A-___: 2 3/8" OD Spinnaker Pole Tube, or 2" Schedule 5 pipe, was a rare size used primarily in California. It is not currently available. |
|
|
|
|
|
2 3/8" OD Custom Poles and Kits As this tube is no longer available, the stronger 2 1/2" Spinnaker Pole tube is recommended for replacement applications. See: 2 1/2" OD Spinnaker Pole & Fittings. |
|
|
|
|
|
2 3/8" OD Spinnaker Pole End Fittings Replacement Pole End Fittings are listed below. Standard End Fittings are suitable for use on the Outboard end of the Pole, and on the Inboard end when a Ring Car (or a fixed Mast Ring) is used on the Mast. Their use on both ends is required when using an End for End jibing procedure. See also: Spinnaker Cars. |
|
|
|
|
|
Standard Pole Ends for 2
3/8" OD Tube Listed below are Standard End Fittings - These pole ends are suitable for either (or both) ends of a spinnaker pole or whisker pole, or the inboard end of a reaching strut. Their use on both ends is required when using an End for End jibing procedure. When used on the Inboard end a Ring Car (or a fixed Mast Ring) is required on the Mast. |
|
|
|
|
|
Aluminum Piston End for 2 3/8" OD Tube: SPC P-0102: Original Sparcraft Cast aluminum Piston End incorporates eyes for attachment of pole lift bridle and foreguy, Piston has hole for attachment of a Trip wire. Piston End has a stainless steel spring-loaded plunger pin that must be manually retracted by pulling on a lanyard, to attach the fitting to a ring or guy. Black anodized fitting is 5 3/4" long, and projects 4 1/2" (maximum) from tube end. # |
 |
|
|
|
~ Back to Spinnaker Poles Main Page ~
~ Home ~