 |
Spars, Rigging, and Hardware for SailboatsRig-Rite, Inc. |
Stanchion Base Backing Plates |
|
|
Spars, Rigging, and Hardware for SailboatsRig-Rite, Inc. |
Stanchion Base Backing Plates |
|
| Stanchion & Rail Base Backing Plates |
| Rig-Rite stocks a variety of 'standard' and undrilled (blank) Backing Plates for Stanchion and Rail Bases, allowing for a more secure installation with virtually any Base. Custom Backing Plates are available on Special Order. |
|
Blank Aluminum Backing Plate for Stanchion Base: SB 36-BPA: Blank (undrilled) Aluminum Backing Plate for Stanchion Bases is 4 1/2" long x 3 1/2" wide x 1/8" thick. Rectangular 6061-T6 Aluminum Plate can easily be drilled to match most Stanchion Bases.
|
|
|
Blank SS Backing Plate for Stanchion Base: SB 36-BPS-B: Blank (undrilled) Stainless Steel Backing Plate for Stanchion Bases is 4 3/8" long x 3 1/2" wide x .104" thick (12 gauge). Rectangular Type 304 SS Plate can be drilled to match most Stanchion Bases.
|
|
|
"H" Pattern Stanchion Base Backing Plate: SB 36-BPS-H: Stainless Steel Backing Plate for "H" Pattern Stanchion Bases is (maximum) 3 3/4" long x 2 7/8" wide x 1/8" thick, with (4) 1/4" holes on 2 1/2" (fore and aft) x 1 5/8" (athwartships) hole centers.
|
 |
|
"T" Pattern Stanchion Base Backing Plate: SB 36-BPS-T: Stainless Steel Backing Plate for "T" Pattern Stanchion Bases is 4" long x 3" wide x 1/8" thick, with (4) 1/4" holes on 2 1/2" (fore and aft) x 2" (athwartships) hole centers.
|
 |
|
Schaefer Pattern Stanchion Base Backing Plate: SB 36-BPS-S: SS Backing Plate for SB 36-S2T-5° Schaefer Trapezoidal SS Stanchion Base with Double Bails. Trapezoidal Backing Plate is (maximum) 5" long x 2 3/4" wide x 1/8" thick, with (4) 1/4" holes on 4" (inboard) x 2 3/4" (outboard) hole centers. |
 |
|
2 1/2" Round SS Backing Plate w/ 3 holes: SB 36-BPS-R2.5H: 2 1/2" Round Stainless Steel Backing Plate is 1/8" thick, with (3) 1/4" holes on a " circle diameter (" between hole centers).
|
|
|
3" Round SS Backing Plate w/ 3 holes: SB 36-BPS-R3H: 3" Round Stainless Steel Backing Plate is 1/8" thick, with (3) 1/4" holes on a " circle diameter (" between hole centers). |
|
~ Back to Stanchion Bases Main Page ~